However there is no guarantee that interference will not occur in a particular installation. Radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. The following statement is required to comply with US and international regulations: Caution: Use of controls, adjustments or performance of procedures ot. Ĭlass 1 Laser devices are not considered to be hazardous when used for their intended purpose. Regulatory Information This device is approved under Symbol Technologies, Inc., a Zebra Technologies company. Provide a suitable working environment.Keep objects that are used frequently within easy reach.Verify that the interface cable connection is connected properly. Troubleshooting Symptom Probable Cause Action Laser beam does not display when pressing the trigger. Cleaning Frequency The cleaning frequency is up to the customer’s disc. Inspect the area for any grease or dirt, repeat if required. Spray compressed air on the connector area by pointing the tube/nozzle about ½ inch away from the surface. Exit Window Wipe the scanner exit window periodically with a lens tissue or other material suitable for cleaning optical material such as eyeglasses. Be careful not to let liquid pool around the display window or o.Ĭleaning the RS419 Housing Using the alcohol wipes, wipe the housing. Do not wrap the device in the cloth or wipe, but gently wipe the unit. Dampen a soft cloth or use pre-moistened wipes. Harmful Ingredi.Ĭleaning Instructions Do not apply liquid directly to the RS419. Ĭleaning Approved Cleanser Active Ingredients 100% of the active ingredients in any cleaner must consist of one or some combination of the following: isopropyl alcohol, bleach/sodium hypochlorite, hydrogen peroxide or mild dish soap. Turn the trigger assembly counter-clockwise until the exit window and. Replacing the Trigger Assembly To replace the trigger assembly: 1. Push the finger strap assembly into the trigger assembly until the release tab clicks into place. Align a new finger strap assembly with the slot in the trigger assembly. Slide the finger strap assembly out of the trigger assembly. For bar codes with bars that are closer together, hold the RS4.Ģ.For larger bar codes, hold the RS419 farther away from the bar code.The terminal beeps if programed accordingly. If the decode is successful the LED turns green. Using the Scanner Not to be used in condensing environments. If required, cut excess finger strap material. Scanner Cable Connector Interface Connectorĥ. Slide the RS419 onto the index finger with the scan trigger next to the thumb. Rotate the trigger assembly so that the scan trigger is positioned next. Determine whether the RS419 is used on the right or left hand. Ĭhanging Trigger Position The trigger assembly of the RS419 rotates to provide left-hand or right-hand use. The RS419 is worn on the operator’s index. The scanner is used with the WT4090 and WT41N0 wearable terminal.
#Motorola symbol n410 user manual code
Introduction The RS419 ring scanner is a modular, wearable laser scanner that allows the operator hands-free bar code scanning capability. Zebra does not assume any product liability arising out of, or in connection with, the application or use of any product, circuit, or application de. Zebra reserves the right to make changes to any product to improve reliability, function, or design.
0 kommentar(er)
